Kids Classical Music

Articles · Lessons and practice

How to change guitar strings: steps for parents

Updated 2026-11-14

Guitar strings lose their bright sound over time, and they break. Changing them is a skill a parent can learn in an afternoon. The steps depend on the kind of guitar. This guide covers classical guitars with nylon strings and acoustic guitars with steel strings, with a note on electric guitars.

Quick facts

  • First, check the type: nylon strings tie on at the bridge. Steel strings have a small ball at one end
  • Never put steel strings on a classical guitar. It is not built for that much pull
  • One at a time is easier for a first try, because you can copy how the old string was put on
  • New strings stretch, nylon strings most of all, so expect to tune often for a few days

Which guitar does your child have?

  • Classical guitar. Nylon strings. The three thin strings look like clear or white plastic. The strings tie onto a block behind the bridge. Many children’s guitars are this type. Read classical guitar for kids.
  • Acoustic guitar with steel strings. All six strings are metal. Small pins hold the strings in the bridge.
  • Electric guitar. Metal strings that pass through the body or a metal bridge. Read electric guitar for kids.

Buy strings made for your type of guitar.

What you need

  • A new set of strings
  • A string winder (it makes winding faster, and many have a notch for pulling bridge pins)
  • Wire cutters for the extra string ends
  • A tuner
  • A soft cloth and a towel to lay the guitar on

Signs it is time

  • The strings sound dull or dead.
  • They will not stay in tune.
  • They look dark, rusty, or rough.
  • A string has broken.

Steel strings with bridge pins

  1. Loosen. Turn the tuning peg to loosen one string until it is slack.
  2. Pull the pin. Lift the bridge pin straight up. The notch on a string winder helps.
  3. Take out the old string. Pull the ball end out of the hole. Unwind the other end from the tuning post.
  4. Put in the new string. Drop the ball end into the hole. Push the pin in, with its groove facing the neck.
  5. Seat the ball. Press down on the pin while you pull up on the string a little. The ball should catch under the bridge.
  6. Thread the post. Pass the string through the hole in the tuning post. Leave enough slack for two or three wraps around the post.
  7. Wind it. Turn the peg so the string wraps down the post in neat coils.
  8. Trim. Snip the extra end with wire cutters.
  9. Tune. Bring the string up to pitch with the tuner. Then do the next string.

Nylon strings on a classical guitar

  1. Loosen and remove. Loosen one string. Unwind it at the head and untie it at the bridge.
  2. Thread the bridge. Push the new string through its hole in the tie block, from the side nearest the sound hole. Leave a tail a few inches long out the back.
  3. Tie it. Bring the tail back over the top of the bridge and loop it under the string. Then tuck the tail under itself against the back of the bridge. On the three thin strings, wrap the tail around two or three times so it does not slip.
  4. Thread the head. At the head, pass the string through the hole in the roller. Loop it once around itself so it holds.
  5. Wind it. Turn the peg so the string wraps over the top of the roller.
  6. Tune and trim. Bring it up to pitch, then trim the extra ends. Do not cut too close to the knot.

The easiest way to learn the knot is to copy one of the strings still on the guitar. That is why one at a time helps.

Stretch the new strings

After the strings are on and tuned, pull each one up away from the fingerboard a little, along its length. Then tune again. Repeat two or three times. Nylon strings will still need tuning for a day or more. Read how to tune a guitar.

Safety

  • Keep faces back from the strings while you tune up. A string can snap.
  • The cut ends of steel strings are sharp. Put them straight in the trash.

When to see a shop

A guitar shop can change strings while you watch. Go to a shop if a bridge pin is cracked, the bridge lifts at the back, or a string buzzes on every fret.

Things to do together

Old and new. Strum the guitar before and after the change. Ask your child what sounds different.

String names. Your child names each string as you change it: E, A, D, G, B, E.

Winding helper. Let your child turn the string winder while you guide the string.

Note the date of the string change on the lesson notes page. For the names of the parts, read parts of the guitar.

Sources

Checked in November 2026.

Use it with your kids

Print a listening page, a practice chart, or a composer fact sheet. Or try a tool, such as the composer timeline or the piece picker.

Free printablesTools